How do I fix EcoFlow Delta Max AC plugs that are not working?
Answer
When Delta Max AC plugs stop working, turn AC output off, unplug all loads from the AC outlets, confirm the battery has enough charge and no overload or fault code is shown, then turn AC back on and test one known-good device. If outlets stay dead with a fault code or after a reset, stop using that output and contact EcoFlow support.
Before you start: stop right away if…
- Portable power stations can present electrical hazards; do not open the case or bypass protection features.
- Persistent fault codes or AC that dies under no load can indicate hardware failure—stop using that output and seek official support.
Follow these steps
Turn AC output off and clear the outlets
On the Delta Max, turn the AC output off using the AC button. Unplug everything from the AC outlets so no overloaded or shorted device remains connected.
You should see: AC output is off and all AC sockets are empty.
Check charge level and status codes
Read the display (and EcoFlow app if linked) for battery percentage and any error or protection codes. Charge the unit if the battery is very low. Note any code exactly before continuing.
You should see: You know whether the unit is low on charge or showing a fault/protection message.
Power-cycle AC output
With no loads connected, turn the Delta Max off if needed, wait about 30 seconds, turn it back on, then turn AC output on again. Listen for the inverter and confirm the AC indicator shows on.
You should see: AC output turns on without an immediate fault, or the same code returns right away.
Test one known-good device
Plug in a simple known-good device such as a phone charger or lamp. Avoid high-draw appliances for the first test. If it works, reconnect other devices one at a time to find a load that trips protection.
You should see: The AC outlet powers the test device, or it fails again and points to overload or an AC hardware fault.
Stop and get service if AC stays dead
If AC will not enable, repeatedly trips with no load, or shows a persistent fault code, leave AC off and contact EcoFlow support with your model, serial number, and the exact code. Do not attempt internal repairs.
You should see: You have the details needed for warranty or support, and you are not continuing to stress a failed inverter.
Not sure this is the right page? Check here
0 of 5 checked
Extra tips
What to look for: AC on/off status on the Delta Max display or app, battery percentage, overload or fault codes, and whether DC USB ports still work while AC does not.
Before you change anything: Unplug sensitive electronics before testing outlets. Do not open the power station case or bypass protection circuits. Keep the unit dry and on a stable surface while testing. Use only the official EcoFlow app or support channels for service.