How do I fix a BlendJet that will not charge?
Answer
A BlendJet that will not charge often needs a known-good USB cable and charger, a clean charge port, and a check against BlendJet’s official recall or support notices for the model.
Before you start: stop right away if…
- Do not open the sealed battery compartment or pierce the battery.
- Stop using the blender if it smells burnt or becomes unusually hot while charging.
Follow these steps
Inspect and dry the charging area
Confirm the USB-C or charge contacts are clean and dry. Remove lint carefully and do not charge while wet.
You should see: Contacts are clean and dry enough to attempt charging.
Try a different cable and 5V wall charger
Connect the BlendJet to a known-good USB cable and wall adapter and leave it charging long enough for a status change.
You should see: Charging indicators behave normally, or both known-good chargers fail.
Reset by charging undisturbed
Leave the blender on the charger for at least 30 minutes without pressing buttons repeatedly, then try a short blend cycle.
You should see: The unit runs, or it still fails despite a full-looking light.
Check official BlendJet support or recall notices
On BlendJet’s official website, look up your model for charging troubleshooting and any recall or replacement programs.
You should see: You find model-specific guidance or a replacement path.
Contact BlendJet support with purchase details
If charging never starts or a full blue light never leads to blending, contact BlendJet support with the model, purchase date, and symptom details.
You should see: Support provides warranty replacement or further diagnostics.
Not sure this is the right page? Check here
0 of 5 checked
Extra tips
What to look for: No charging progress, a blue light that claims full charge while the blender will not run, and debris in the USB or contact area.
Before you change anything: Use the cable and charging method BlendJet documents for your model. Check BlendJet’s official support or recall pages for your exact model. Do not submerge the power base while troubleshooting. Stop using the device if it overheats abnormally.