How do I fix GloryFit when it will not connect to a smartwatch?
Answer
GloryFit pairing usually fails because of a Bluetooth glitch or because the watch was paired from the phone’s Bluetooth menu instead of inside GloryFit. Toggle Bluetooth, restart phone and watch, then start pairing only from within the GloryFit app.
Before you start: stop right away if…
- Do not install GloryFit APKs from unknown sites that ask for unusual permissions or payment to unlock pairing.
Follow these steps
Refresh Bluetooth
On the phone, turn Bluetooth off, wait a few seconds, then turn it back on. Keep the watch awake and close to the phone.
You should see: Bluetooth restarts cleanly and nearby devices can be scanned again.
Restart phone and watch
Restart the phone. Restart the watch if it has a restart option (or power it off and on). Wait until both finish booting.
You should see: Both devices are responsive before you open GloryFit again.
Forget old Bluetooth pairings if needed
In the phone’s Bluetooth settings, forget/unpair any existing entry for the watch so it is not stuck in a half-paired state.
You should see: The watch no longer appears as a saved Bluetooth device on the phone.
Pair from inside GloryFit
Open GloryFit and use Add device / Pair from inside the app—do not complete pairing only from the phone’s Bluetooth menu. Select the P121 or matching model when it appears.
You should see: GloryFit connects to the watch and shows it as paired or synced.
Not sure this is the right page? Check here
0 of 5 checked
Extra tips
What to look for: Whether GloryFit finds the watch during in-app pairing, any on-screen error while scanning, and whether the watch was previously listed under the phone’s Bluetooth settings.
Before you change anything: Charge the watch and keep it next to the phone. Confirm the GloryFit app name matches your watch brand’s recommended app. Note the watch model (for example P121) shown in the app’s device list. Avoid random APKs outside the official app store listing for GloryFit.