How do I stop buzzing and silence on cordless phone calls?
Answer
Buzzing on all handsets with no clear audio usually means interference or a bad base connection, not a single faulty handset. Power-cycle the Uniden base and phone line for one full minute, then test again on a known-good wall jack.
Follow these steps
Power-cycle the base and phone line
Unplug the Uniden base power adapter and the phone-line cord from the wall jack. Wait a full minute, then plug the phone line back in first and the power adapter second. Wait until the base finishes its startup lights.
You should see: Handsets reconnect to the base and dial tone sounds clearer than before.
Test away from interference
Move the base a few feet from Wi-Fi routers, microwave ovens, and power strips. Place a call and listen on two different handsets.
You should see: Buzzing drops or disappears when the base is farther from other electronics.
Compare with a corded phone
If you have a basic corded phone, plug it into the same wall jack and listen to dial tone and a short call. If the corded phone is also noisy, the jack or phone service needs attention next.
You should see: You know whether the noise is in the cordless system or on the line itself.
Try another jack or filter
Move the base to another phone jack in the home, or remove any unused DSL/filter splitters on that jack, then retest. Contact your phone provider only if a corded phone on the same jack stays noisy.
You should see: Calls are clear on the new jack, or you have a clear line issue to report to the provider.
Not sure this is the right page? Check here
0 of 5 checked
Extra tips
What to look for: Buzzing on every handset during dial tone and calls, whether audio improves when the base is moved away from Wi-Fi routers or power strips, and whether a corded phone on the same jack is clear.
Before you change anything: Note the base brand and model if printed on the unit. Keep handsets nearby so you can test immediately after reconnecting. Do not pay anyone who cold-calls offering to “fix your phone line.” Avoid factory-resetting the base until a simple power and line reboot is tried.