How do I get a Roland Fantom EX to appear in Logic Pro on macOS?
Answer
Install the official FANTOM EX USB driver from Roland before opening Logic, allow it in macOS privacy settings if prompted, then select the Fantom as an audio/MIDI device in Logic.
Before you start: stop right away if…
- Install audio drivers only from Roland’s official website.
Follow these steps
Download the official FANTOM EX USB driver
On Roland’s official support site, download the FANTOM EX USB driver package that matches your macOS version.
You should see: You have the correct installer from Roland, not a third-party copy.
Install the driver before launching Logic
Quit Logic Pro, run the Roland installer, approve any system extension or security prompts in System Settings, and reboot if the installer requests it.
You should see: The driver installs and macOS security settings allow it.
Connect the Fantom and power it on
Connect the Fantom EX directly to the Mac with a known-good USB cable, power the instrument on, and wait until it finishes booting.
You should see: The Mac recognizes a USB audio/MIDI device in system information or Audio MIDI Setup.
Select the Fantom in Logic’s audio/MIDI settings
Open Logic Pro, go to audio settings / MIDI studio options as needed, and choose the Fantom EX as an input, output, or MIDI device.
You should see: Logic lists the Fantom EX and can receive MIDI or audio from it.
Recheck privacy settings if it still does not appear
In System Settings, confirm Roland’s driver or related audio extensions are allowed, try another USB port, and reopen Logic only after the Fantom is already powered on.
You should see: The Fantom appears in Logic, or Roland support is needed for macOS compatibility confirmation.
Not sure this is the right page? Check here
0 of 5 checked
Extra tips
What to look for: Roland’s official FANTOM EX macOS driver download, Logic’s audio device menu, and macOS prompts about system extensions or developer software.
Before you change anything: Download drivers only from Roland’s official support site. Note your exact macOS version. Quit Logic before installing drivers. Use a direct USB cable rather than an unpowered hub when possible.