How do I replace the battery in TV Ears long-range 5.8 GHz headset?
Answer
Order the correct TV Ears replacement battery for your exact headset model, then power the headset off, open the battery compartment, and swap the pack using the same connector orientation. If runtime stays very short with a new OEM battery, the charging cradle or cable may also be failing.
Before you start: stop right away if…
- Do not puncture, bend, or incinerate lithium battery packs.
Follow these steps
Identify the exact battery part
Find the model name on the headset or original box and order the official or listed-compatible TV Ears replacement battery for that model.
You should see: The battery listing matches your headset model.
Power off and open the compartment
Turn the headset off, remove any small screws on the battery cover with a proper Phillips driver, and open the case carefully without prying against the board.
You should see: The battery pack is visible and accessible.
Swap the battery pack
Disconnect the old pack, connect the new pack in the same orientation, seat it flat, and reassemble the cover screws.
You should see: The headset powers on and shows a normal charging indication in the cradle.
Charge fully and retest runtime
Charge undisturbed according to the manual, then time a normal listening session. If runtime is still about an hour, test with another known-good cradle/cable if available.
You should see: Listening time returns to expected length, or charging hardware becomes the next suspect.
Not sure this is the right page? Check here
0 of 5 checked
Extra tips
What to look for: TV Ears branding on the box, runtime of about one hour from full charge, and the exact headset model for battery fit
Before you change anything: Turn the headset fully off. Order a battery listed for your TV Ears model. Use a proper small Phillips driver if screws are present. Do not puncture or crush the old battery pack.